Daily maintenance and maintenance of automatic scimitar machine

In the process of using the active machete machine, how do we usually clean and maintain the computer active machete machine? This should be a question that buyers want to know very much. No matter what product we use, things will always get dirty after a long time. It is the same as the clothes we usually wear every day. The machete machine must be cleaned frequently. It is important to clean frequently to avoid aging. Accumulating too much waste will affect its function, just like people will be inflexible if they don't use their brains for too long.

After we buy the scimitar machine home, we must perform a comprehensive cleaning and maintenance of the scimitar machine after working for two or three working days. How to do it? The following are some commonly used methods.

1. Use WD-40 anti-rust oil to spray an appropriate amount of anti-rust oil on the shearing up and down, moving the scissors left and right, and shearing the sliding block.

2. Loosen the front and rear hexagonal socket screws of the front cover at the main rail, remove the front and rear covers, and spray an appropriate amount of anti-rust oil on the upper and lower sides of the zigzag rod and the opening of the main rail.

3. For the olecranon mold, spray an appropriate amount of anti-rust oil in the gap of the olecranon concave-convex mold that often runs up and down.

4. Open the upper machine cover, take out the bridge mold and spray an appropriate amount of anti-rust oil; the feeding chassis and the knife material inlet also need to spray an appropriate amount of anti-rust oil.

5. After all the above vulnerable parts are sprayed with an appropriate amount of anti-rust oil, clean each part of the above vulnerable parts with (no water droplets in the air pipe), and clean the iron filings and dust inside to make the anti-rust oil Spread evenly on each part, and then use a clean cloth to clean the surface of the machine.

6. Clean the machine guide rail part, remove the disc knife, spray a rice knife evenly with anti-rust oil, then insert the knife material into the guide rail, pull it back and forth twice, then take out the knife material, the knife material will take out part of the guide rail Clean the dust and impurities inside, and then wipe the knife material with a cloth. Repeat this many times to clean the guide rails, and at the same time use air to clean the guide rails.